Klein 1613-35 Chicago Grip for Bare Copper Wire
Finding the best grip to pull small copper can be challenging. Copper stretches over time becoming too thin for some grips which may cause slippage. Some smaller grips are harder to manipulate when wearing rubber gloves and are not hot latch compatible. Using a grip that's too big, too strong or too aggressive could damage the cable. Klein Tools' 1613 Series Bare Wire Chicago Grip is big enough to work with gloves but small enough to pull No. 6 and No. 8 copper without damaging it. It's just right for the job.
- Maximum Safe Load: 4500 lb
- Cable Diameter: No. 8 AWG Bare Copper to No. 6 AWG Bare Copper
- Sub Brand: Chicago Grip
- Weight: 2.9 lb
- Jaw Length: 4-3/16in.
- Locking Handle: Y
- Hot Latch: —
- Spring: Y
Before each use, clean jaw area and inspect grip for proper operation to avoid slippage. When used on/near energized lines, ground, insulate, or isolate grip before pulling. Do not exceed rated capacity. Do not exceed rated capacity. Grips are to be used for temporary installation, not for permanent anchorage.
- F1Pulls No. 6 to No. 8 bare copper wire.
- F2Safe load of 4,500 lbs
- F3Locking loop handles allow the jaws to be held in an open position for easy placement on wire or cable.
- F4Single in.Vin. groove jaw contour.
- F5Hot latch version available .
- UPC092644471919
- MPN1613-35