Wedge Anchors from Jim & Slim's Tool Supply - Jim & Slims Tool Supply

Wedge Anchors

The Wedge-All is a non-bottom bearing, wedge style expansion anchor for use in solid concrete or grout filled masonry. A one-piece clip ensures uniform holding capacity that increases as tension is applied. The threaded stud version is available in nine diameters and multiple lengths. A single size tie-wire version is available for wire supported fixtures. Threaded studs are set by tightening the nut. Tie-wire anchors are set with the claw end of a hammer.


  • One piece wrap around clip
  • Threaded end is chamfered for ease of starting nut.
  • Most sizes feature full thread for added versatility.


Carbon and stainless steel.


Carbon steel anchors are available zinc plated or mechanically galvanized.


Wedge anchors shall be a threaded stud with an integral cone expander and a single piece expansion clip. The stud shall be carbon steel with a minimum 70,000 psi tensile strength, or type 303, 304 or 316 stainless steel, as called for on the drawings. Anchors shall meet Federal Specification A-A-1923A, Type 4. Anchors shall be Wedge-Alls from Simpson-Strong Tie, Pleasanton, CA. Anchors shall be installed following Simpson Strong-Tie's instructions for Wedge-Alls.

Narrow Your Search Below...



Please Wait... processing