The Wedge-All is a non-bottom bearing, wedge style expansion anchor for use in solid concrete or grout filled masonry. A one-piece clip ensures uniform holding capacity that increases as tension is applied. The threaded stud version is available in nine diameters and multiple lengths. A single size tie-wire version is available for wire supported fixtures. Threaded studs are set by tightening the nut. Tie-wire anchors are set with the claw end of a hammer.
- Code ReportsICC/ICBO ER-3631;
City of L.A. RR24682;
Dade County 01-0820.06;
Factory Mutual 3017082;
Florida Statewide Product Approval FL402.4;
Underwriters Laboratories File Ex3605;
Meets requirements of Federal Specifications A-A-1923A, Type 4.
The Load Tables list values based upon results from the most recent testing and may not reflect those in current code reports. Where code jurisdictions apply, consult the current reports for applicable load values.
- Special FeaturesOne piece wrap around clip
Threaded end is chamfered for ease of starting nut.
Most sizes feature full thread for added versatility.
- Suggested SpecificationsWedge anchors shall be a threaded stud with an integral cone expander and a single piece expansion clip. The stud shall be carbon steel with a minimum 70,000 psi tensile strength, or type 303, 304 or 316 stainless steel, as called for on the drawings. Anchors shall meet Federal Specification A-A-1923A, Type 4. Anchors shall be Wedge-Alls from Simpson-Strong Tie, Dublin, CA. Anchors shall be installed following Simpson Strong-Tie's instructions for Wedge-Alls.
- Test CriteriaThe Wedge-All anchor has been tested in accordance with ICBO's Acceptance Criteria for Expansion Anchors in Concrete and Masonry Elements (AC01). ICBO report ER-3631 recognizes the carbon and stainless steel Wedge-All for the following:
Static Tension and Shear Loading.
Seismic and Wind Loading.
Combination Tension and Shear Loading.
Critical and Minimum Edge Distance.